skip to main content

Rancang Bangun 6-DoF Welding Arm Manipulator Robot Berbasis STM32

*Alfonsus Giovanni  -  Universitas Diponegoro, Indonesia
Fakhruddin Mangkusasmito  -  Universitas Diponegoro, Indonesia

Citation Format:
Abstract

In the era of Industry 4.0, the demand for automation in the manufacturing sector continues to grow, particularly in welding processes that require high efficiency, consistency, and quality. Robotic arm manipulators have become a widely adopted solution in various countries, including Indonesia. However, the dominance of imported products poses challenges such as high investment costs and limited customization capabilities. This research aims to design and develop a six-degree-of-freedom (6-DoF) welding robotic arm manipulator using the STM32H7 microcontroller as the main control system. The STM32H7 was selected for its high processing performance, low power consumption, and flexibility in integrating sensors and actuators. The outcomes of this study are expected to contribute as an alternative solution for the development of domestic industrial robotics, thereby reducing reliance on imported technologies and supporting national technological self-sufficiency. Several tests were conducted on the developed system, including repeatability testing. The results indicate that the prototype achieved a repeatability value of ±0.225 mm, which is still lower than that of comparable industrial-grade systems (±0.02 mm). This finding suggests that while the system shows promise, further refinement is required to meet industrial performance standards

Keywords: arm manipulator robot, welding, STM32H7, 6-DoF, automation, Industry 4.0.

Article Metrics:

  1. Ahmad Didik Setiyadi, Iwan Setiawan. “Perancangan Dan Pengendalian Manipulator Robot 4-DOF Dengan Gripper Berbasis Inverse Kinematics Dan Trajectory Planning Dengan ROS,” Transient, vol. 10, no.4, pp.552-558, Des, 2021
  2. Almaz Sayyid Hadziq, Munawar Agus Riyadi. “Desain Dan Pembuatan Lengan Artikulasi 5-DOF Sebagai Pemisah Dan Pemindah Benda Berdasarkan Warna,” Transient, vol. 9, no.3, pp.428-435, Sept, 2020
  3. Altino Louriero, Gunnar Bolmsjo, J. Norberto Pires. (1987). Welding Robots Technology, System Issues and Application
  4. Hanfi Fadzillah, Iwan Setiawan. “Perancangan Manipulator Robot Bedah 6-DOF Dengan Remote Center Of Motion Mekanik Berbasis Inverse Kinematics,” Transient, vol. 12, no. 3, pp.102-108, Sept, 2023
  5. Lee, J., Kim, K., Kim, Y., & Lee, J. “Singularity Avoidance Path Planning on Cooperative Task of Dual Manipulator Using DDPG Algorithm,”
  6. The Journal of Korea Robotics Society, vol. 16, no.2, pp.137-146, Mei, 2021
  7. G. Charmichael, Dika Liu. “A Framework for Singularity-Robust Manipulator Control During Physical Human-Robot Interaction,” The International Journal of Robotic Research, vol. 36, no. 5-7, pp.861-876, Juni, 2017
  8. Tran Thanh Tung, Nguyen Van Tinh (2023). Development of A Prototype 6 Degree of Freedom Robot Arm

Last update:

No citation recorded.

Last update: 2026-11-18 23:28:02

No citation recorded.