skip to main content

A Bamboo-Hybrid-Slat Laminate of Fishing Boat: Materials Selection, Scantling Calculation and Construction Cost

*Heri Supomo scopus  -  Department of Naval Architecture, Faculty of Marine Technology, Sepuluh Nopember Institute of Technology,, Indonesia
Eko Budi Djatmiko  -  Department of Ocean Engineering, Faculty of Marine Technology, Sepuluh Nopember Institute of Technology,, Indonesia
Wikaranosa Supomo  -  Baito Deling Research,, Indonesia
Rizki Dian Permana  -  National Research and Innovation Agency of Indonesia, Indonesia
Open Access Copyright (c) 2021 Kapal: Jurnal Ilmu Pengetahuan dan Teknologi Kelautan under http://creativecommons.org/licenses/by-sa/4.0.

Citation Format:
Cover Image
Abstract

Abstract. Bambusa Arundinacea slat lamination has relatively high tensile and flexure strength, while Pterocarpus Indicus has relatively lower than. These two types of bio-materials are very cheap, easy to cultivate, fast growing, and renewable material. For this reason, hybrid slats lamination of Bambusa Arundinacea and Pterocarpus Indicus was chosen as a construction material for fishing boats to substitute solid Teak wood which is increasingly rare and expensive. Based on the results of the tensile and flexural strength tests show that the configuration of the hybrid laminated with the parallel slats has the highest tensile strength (114.636 MPa) and flexural strength (111.606 MPa). These two strength values are used to calculate the 20GT fishing boat scantling in accordance with the Indonesian Classification Bureau vol vii 2013 regulations. By using the hybrid lamination material of Bambusa Arundinacea - Pterocarpus Indicus slats, the scantling of 20GT fishing boat will be slightly smaller, the volume of material needed is 28.7% lower and the construction cost 40.66.% less than Teak wood material.

Fulltext View|Download
Keywords: hybrid slat laminate, Bambusa Arundinacea, Pterocarpus Indicus, Scantling, Construction Cost

Article Metrics:

Last update:

  1. Correlation between lamina directions and the mechanical characteristics of laminated bamboo composite for ship structure

    Tuswan Tuswan, Parlindungan Manik, Samuel Samuel, Agus Suprihanto, Sulardjaka Sulardjaka, Sri Nugroho, Boris Ferdinando Pakpahan. Curved and Layered Structures, 10 (1), 2023. doi: 10.1515/cls-2022-0186
  2. Analysis of the tensile and bending strengths of the joints of “Gigantochloa apus” bamboo composite laminated boards with epoxy resin matrix

    Parlindungan Manik, Ahmad Firdhaus, Tuswan Tuswan, Kiryanto Kiryanto, Bagus Muhammad Ichsan. Journal of the Mechanical Behavior of Materials, 32 (1), 2023. doi: 10.1515/jmbm-2022-0276

Last update: 2024-03-28 20:09:37

No citation recorded.