DOI: https://doi.org/10.14710/rotasi.8.4.1-4

MATCHING AND STITCHING FOR SURFACE IDENTIFICATION

*Jamari Jamari  -  Staff pengajar jurusan teknik mesin UNDIP, Indonesia

Citation Format:
Abstract
An algorithm to determine changes in surface topography on asperity level has been developed in this paper. The software tool stitches small but detailed images together to create one large image. If such an image is made before and after an experiment, their difference shows a direct 3D view of the changes in micro-geometry, rather than a change in surface parameters such as RMS or CLA roughness. The algorithm is described in detail and demonstrated by appling to real rough surfaces.
Fulltext View|Download Email colleagues

Article Metrics:

Article Info
Section: Articles research
Language : EN
Most cited articles
PENGGUNAAN PARAFFIN WAX SEBAGAI PENYIMPAN KALOR PADA PEMANAS AIR TENAGA MATAHARI THERMOSYPHON PENGARUH SUHU TEMPERING TERHADAP KEKERASAN, KEKUATAN TARIK DAN STRUKTUR MIKRO PADA BAJA K-460 MATCHING AND STITCHING FOR SURFACE IDENTIFICATION PENGEMBANGAN PERANGKAT LUNAK SISTEM INTERPOLATOR MESIN MULTI MATERIAL DEPOSITION INDIRECT SINTERING (MMD-Is) Pengaruh Post Weld Heat Treatment (Pwht) dengan Pemanas Induksi Terhadap Sifat Mekanik dan Struktur Mikro Sambungan Las Shield Metal Arc Welding (Smaw) pada Pipa API 5l X52 More cited articles

Last update:

No citation recorded.

Last update: 2026-10-26 20:25:54

  1. An experimental investigation of steel surface topography transfer by cold rolling

    Xu D.. Micromachines, 11 (10), 2020. doi: 10.3390/mi11100916