DOI: https://doi.org/10.14710/jis.%25v.%25i.%25Y.392-405

THE USE OF TWO-DIMENSIONAL AUTOCORRELATION OF VIBRATION SIGNAL FOR FAULT DETECTION OF RECIPROCATING COMPRESSORS

*Achmad Widodo  -  Department of Mechanical Engineering, Diponegoro University, Indonesia
Satrio Budi Prasojo  -  Department of Mechanical Engineering, Diponegoro University, Indonesia
Ismoyo Haryanto  -  Department of Mechanical Engineering, Diponegoro University, Indonesia
Open Access Copyright (c) 2017 ROTASI

Citation Format:
Abstract

Reciprocating compressors are the oldest kind of compressors designed for mass production. These compressors still become- the best choice for several industrial application due to their advantages that give high compression ratio and low mass flow. There are many cases of reciprocating compressors faults, such as fault in valve, wrist-pin, and crankpin bore on connecting rod. In this paper, fault detection of such compressors due to exhaust valve and pin bore faults will be presented based on the vibration signal. At first, time domain and frequency domain will be the basic method for analysis and then it will be completed by spectrogram and two-dimensional autocorrelation. The patterns of vibration signals were analyzed and compared through their vibration signatures. Vibration signatures could give informations related to impending faults in the compressors. Therefore, the fault diagnostics of compressor could be realized

Fulltext View|Download
Keywords: Autocorrelation, compressor, fault detection, spectrogram

Article Metrics:

Article Info
Section: Articles research
Recent articles
Front Matter Rotasi Vol. 18 No. 1 Januari 2016 PENGARUH FRAKSI VOLUME SERAT DAN LAMA WAKTU PERENDAMAN NaOH TERHADAP KEKUATAN IMPAK KOMPOSIT POLIESTER BERPENGUAT SERAT IJUK PENGARUH TEKSTUR PERMUKAAN MATERIAL UHMWPE TERHADAP DISTRIBUSI TEGANGAN PADA BEBAN KONTAK STATIC, ROLLING DAN SLIDING PHYSICAL AND MECHANICAL CHARACTERIZATION OF AL-SI ALLOYS WITH THE ADDITION OF MG AS MATERIAL OF THE CHASSIS MODEL MADE BY THE HIGH-PRESSURE DIE-CASTING (HPDC) Back Matter Rotasi Vol. 18 No. 1 Januari 2016 More recent articles
Most cited articles
WEAR PREDICTION USING GIWM (GLOBAL INCREMENTAL WEAR MODEL) METHOD ANALISIS EFISIENSI RAW GRIDING MILL PADA PROSES PEMBUATAN SEMEN PENGGUNAAN PARAFFIN WAX SEBAGAI PENYIMPAN KALOR PADA PEMANAS AIR TENAGA MATAHARI THERMOSYPHON PEMANFAATAN ABU VULKANIK GUNUNG KELUD SEBAGAI BAHAN ADITIF DALAM PEMBUATAN CETAKAN PENGECORAN LOGAM Pengaruh konsentrasi larutan dan kuat arus terhadap ketebalan pada proses pelapisan nikel untuk baja karbon rendah More cited articles

Last update:

No citation recorded.

Last update: 2024-11-15 08:08:48

No citation recorded.