DOI: https://doi.org/10.14710/rotasi.3.1.39-43

PENGARUH PEREGANGAN TERHADAP PENURUNAN LAJU PERAMBATAN RETAK MATERIAL AL- 2024 T3

*Susilo Adi Widyanto  -  Staf pengajar jurusan teknik mesin FT-UNDIP, Indonesia

Citation Format:
Abstract
Streching process of sheet materials is one of any process to increasing of material strength. But the effect of this
process on crack growth must investigate, the first for sheet materials are used as a plane structure.
The test results show that the streching process of AL 2024 T3 materials of 3 % would produce of decreasing
crack growth rate, and 5 % of streching process would produce of increasing crack growth rate of materials.
Fulltext View|Download

Article Metrics:

Article Info
Section: Articles research
Language : EN
Recent articles
ANALISA KELUAR REL KERETA API DIFFUSION BONDING : AN ADVANCED OF MATERIAL PROCESS EFEK KONDUKSI PANAS DALAM SILINDER PEJAL PADA PENGUJIAN PERPINDAHAN PANAS DENGAN FLUK KALOR TETAP More recent articles
Most cited articles
Pengukuran Distribusi Beban Telapak Kaki Manusia Saat Berdiri Tegak Menggunakan Sensor FSR 402 Application of Power Plant 4.0: Process Digitalization and Challenges PENGGUNAAN PARAFFIN WAX SEBAGAI PENYIMPAN KALOR PADA PEMANAS AIR TENAGA MATAHARI THERMOSYPHON Pengaruh Post Weld Heat Treatment (Pwht) dengan Pemanas Induksi Terhadap Sifat Mekanik dan Struktur Mikro Sambungan Las Shield Metal Arc Welding (Smaw) pada Pipa API 5l X52 Application of Polishing AISI 316L Stainless Steel Ball Bearing with A Magnetic Abrasive Finishing Process: A Review More cited articles

Last update:

No citation recorded.

Last update: 2024-11-14 02:54:30

No citation recorded.