skip to main content

Pengaruh Bentuk Grip terhadap Linearitas Daerah Elastis Kurva Uji Tarik Logam

*Rusnaldy Rusnaldy  -  Diponegoro University, Indonesia
Open Access Copyright (c) 2026 ROTASI

Citation Format:
Abstract

Tensile tests conducted previously have occasionally yielded non-linear stress-strain curves within the elastic deformation region. Several factors could be responsible for this, one of which relates to the type of grip employed—specifically, the wedge grips that were being used. Inspection of the grip surfaces revealed that some of the teeth had undergone wear. To improve the tensile test data, new grips—referred to as "jaw grips"—were fabricated. Subsequently, tensile tests were performed on four types of materials—AISI 1018 steel, AISI 1045 steel, 6061-T6 aluminum alloy, and C36000 brass—using both types of grips. A numerical analysis using the Finite Element Method (FEM) in ANSYS was also carried out to determine the maximum von Mises stress occurring in the grips, the safety factor, and the potential for slippage during the tensile tests. The results demonstrate that replacing the wedge grips with the new jaw grips produces a linear stress-strain curve in the elastic deformation region. Furthermore, the FEM analysis indicates that the jaw grips result in lower maximum von Mises stress, a higher safety factor, and the elimination of slippage during tensile testing compared to the use of wedge grips.

Keywords: Tensile testing, grip, stress-strain curves, linearity, and slip

Article Metrics:

Last update:

No citation recorded.

Last update: 2026-11-16 14:23:18

No citation recorded.