PERBANDINGAN TEKNIS DAN EKONOMIS ANTARA PENGGANTIAN BANTALAN POROS PROPELLER DIBANDINGKAN DENGAN PENGGESERAN POSISI V-BRACKET PADA KMP. KUMALA

Abstract
In the propulsion systems there are three preference components main engine, propeller shaft, and propeller.KMP. Kumala is one for all passengers ship the owner PT. Darma Lautan Utama, there are it’s to experienceproblems to the systems propulsion to happen missalignment between construction v-bracket with sterntube,there are v-bracket to function become to hold up propeller shaft in the inside to find shaft bearing. Effect themissalignment, shaft can’t to turn, so need the realized preparing with the change to shaft bearing shapeexentric and to scrape position v-bracket the position again. In this finish task purporting to know the valuefrom side technics and economics between to realized the change shaft bearing shape exentric with to scrapeposition v-bracket to position again with account time to docking next time. From the result analyse to find thatto change the shaft bearing shape exentric to need faster time, material cost is more expensive, labour cost ischeaper, construction to v-bracket isn’t normaly, than to scrape position v-bracket to need the time is long time,material cost is cheaper, job cost is more expensive, construction v-bracket back to normal the position again,until to moment realization docking next time to need faster time, material cost and job cost is cheaper from tochange the shaft bearing shape exentric.
Keywords: Propeller shaft, Bearing, Exentric, V-bracket, Thordon
Article Metrics:
Others articles
PENGGUNAAN ABU SEKAM PADI SEBAGAI ADSORBEN DALAM PENGOLAHAN AIR LIMBAH YANG MENGANDUNG LOGAM Cu
PENURUNAN MODEL PERMUKAAN DIJITAL (DSM) MENJADI MODEL ELEVASI DIJITAL (DEM) DARI CITRA SATELIT ALOS PALSAR (Studi kasus: NAD Bagian Tenggara, Indonesia)
INVENTARISASI PERUBAHAN WILAYAH PANTAI DENGAN METODE PENGINDERAAN JAUH (STUDI KASUS KOTA SEMARANG)
Pembuatan Briket Arang Dari Campuran Tempurung Kelapa dan Serbuk Gergaji Kayu Sengon
PERMASALAHAN AIRTANAH PADA DAERAH URBAN
LIFE CYCLE ASSESSMENT OF PAPER TOWEL AND ELECTRIC DRYER AS HAND DRYING METHOD IN THE UNIVERSITY OF MELBOURNE
Last update: 2021-02-23 23:45:12
No citation recorded.
Last update: 2021-02-23 23:45:13
No citation recorded.
The Authors submitting a manuscript do so on the understanding that if accepted for publication, copyright of the article shall be assigned to jurnal TEKNIK and Faculty of Engineering, Diponegoro University as publisher of the journal.
Copyright transfer agreement can be found here: [Copyright transfer agreement in doc] and [Copyright transfer agreement in pdf].