DOI: https://doi.org/10.12777/jati.2.1.1-10

Running-in as an Engineering Optimization

*Jamari Jamari  -  Department of Mechanical Engineering, Faculty of Engineering, Diponegoro University, Indonesia

Citation Format:
Abstract

Running-in is a process which can be found in daily lives. This phenomenon occurs after the start of the contact between fresh solid surfaces, resulting in changes in the surface topography, friction and wear. Before the contacting engineering solid surfaces reach a steady-state operation situation this running-n enhances the contact performance. Running-in is very complex and is a vast problem area. A lot of variable occurs in the running-in process, physically, mechanically or chemically. These transient phenomena should be optimized so that it is beneficial. In this paper the global analysis of running-in in term of engineering optimization is presented.  Literature that reports of what have been published about knowledge and ideas, on the running-in topic by accredited scholars and researchers, are reviewed. The running-in model which can predict the real engineering surfaces in its operation is proposed.

Key words: optimization, running-in, elastic-plastic contact, friction, wear,

Fulltext View|Download

Article Metrics:

Article Info
Section: Case Studies
Language : EN
Recent articles
OPTIMASI CUTTING STOCK PADA INDUSTRI PEMOTONGAN KERTAS DENGAN MENGGUNAKAN METODE INTEGER LINEAR PROGRAMMING (Studi Kasus di Bhinneka – Semarang) Running-in as an Engineering Optimization Rancang Bangun Alat Uji Komposisi Massa Pada Logam Paduan Berdasarkan Prinsip Gaya Angkat Fluida More recent articles
Most cited articles
MODEL PEMILIHAN BAHAN PEWARNA ALAM COKLAT BATIK TULIS SOLO DENGAN MENGGUNAKAN METODE ANALYTICAL HIERARCHY PROCESS (AHP) ANALISIS FAKTOR-FAKTOR YANG MEMPENGARUHI KEPUTUSAN PEMBELIAN VIA INTERNET PADA TOKO ONLINE ANALISIS PENGARUH TEMPERATUR LINGKUNGAN, BERAT BADAN DAN TINGKAT BEBAN KERJA TERHADAP DENYUT NADI PEKERJA GROUND HANDLING BANDARA PENGARUH PENERAPAN PERIKLANAN DI INTERNET DAN PEMASARAN MELALUI E-MAIL PRODUK UMKM DI WILAYAH DEPOK INTEGRASI METODE ANP DAN TOPSIS DALAM EVALUASI KINERJA SUPPLIER DAN PENENTUAN PRIORITAS SUPPLIER BAHAN BAKU UTAMA CETAK KORAN PADA PT MASSCOM GRAPHY SEMARANG More cited articles

Last update:

No citation recorded.

Last update: 2024-11-22 20:08:55

No citation recorded.