skip to main content

Analysis of Energy Use Intensity (EUI) Factors in Government Office Buildings in Tropical Climate: A Case Study in the Ministerial Office Building and the Directorate General of Water Resources Building of The Ministry of Public Works

*Diana Kusumastuti  -  Doctoral Program in Architectural and Urban Science, Universitas Diponegoro, Jl. Prof. Soedarto, S.H., Tembalang, Semarang, Indonesia, 50275, Indonesia
Erni Setyowati  -  Architecture Study Program, Faculty of Engineering, Universitas Diponegoro, Jl. Prof. Soedarto, S.H., Tembalang, Semarang, Indonesia, 50275, Indonesia
Suzanna Sari  -  Architecture Study Program, Faculty of Engineering, Universitas Diponegoro, Jl. Prof. Soedarto, S.H., Tembalang, Semarang, Indonesia, 50275, Indonesia
Agung Dwiyanto  -  Architecture Study Program, Faculty of Engineering, Universitas Diponegoro, Jl. Prof. Soedarto, S.H., Tembalang, Semarang, Indonesia, 50275, Indonesia
Open Access Copyright (c) 2025 TEKNIK

Citation Format:
Abstract

Energy Use Intensity (EUI) is a key indicator for evaluating the energy efficiency of buildings. This study aims to analyze the EUI factors in two government office buildings: the Ministerial Office (MO) building and the Directorate General of Water Resources (DGWR) building of The Ministry of Public Works. Both are located in close proximity and share similar physical characteristics under tropical climate. The EUI is analyzed using the walkthrough audit method as a practical approach for assessing energy performance. The results show that the DGWR Building exhibits higher energy consumption, primarily due to the dominance of cooling loads accounting for 54.13% of the total EUI, compared to 46.54% at the MO building.  There are three main factors contributing to the EUI variation include: (i) heating, ventilation, and air conditioning (HVAC) system – the water-cooled chiller used in the MO building shows higher efficiency compared to the air-cooled chiller system installed in the DGWR building; (ii) Overall Thermal Transfer Value (OTTV) – although both buildings utilize similar envelope materials, the OTTV value in DGWR building is significantly higher due to its larger window-to-wall ratio (WWR), which increases heat gain through the facade; and (iii) Lighting – while there is no significant difference in total installed lighting power, the higher lighting power density (LPD) in DGWR building contributes to a greater lighting energy load per unit area. Additionally, the implementation of smart lighting systems in MO building contributes to better energy efficiency performance.

Fulltext View|Download
Keywords: energy use intensity; EUI; government office buildings; energy efficiency; tropical climate

Article Metrics:

  1. Ahn, K. U., Shin, H. S., & Park, C. S. (2019). Energy Analysis of 4625 Office Buildings in South Korea. Energies, 12(6), 1114. https://doi.org/10.3390/en12061114
  2. Ali-Tagba, A. R., Baneto, M., & Lucache, D. D. (2024). Factors Influencing the Energy Consumption in a Building: Comparative Study between Two Different Climates. Energies, 17(16). https://doi.org/10.3390/en17164041
  3. Ardente, F., Beccali, M., Cellura, M., & Mistretta, M. (2011). Energy and environmental benefits in public buildings as a result of retrofit actions. Renewable and Sustainable Energy Reviews, 15(1), 460–470. https://doi.org/10.1016/j.rser.2010.09.022
  4. Choi, J. H. (2017). Investigation of the correlation of building energy use intensity estimated by six building performance simulation tools. Energy and Buildings. https://www.sciencedirect.com/science/article/pii/S0378778817314871
  5. Chung, W. (2011). Review of building energy-use performance benchmarking methodologies. Applied Energy. https://www.sciencedirect.com/science/article/pii/S030626191000485X
  6. Garg, V., Chandrasen, K., Tetali, S., & Mathur, J. (2010). EnergyPlus Simulation Speedup Using Data Parallelization Concept. ASME 2010 4th International Conference on Energy Sustainability, 1041–1047. https://doi.org/10.1115/ES2010-90509
  7. Gassar, A. A. A., Koo, C., Kim, T. W., & Cha, S. H. (2021). Performance optimization studies on heating, cooling and lighting energy systems of buildings during the design stage: A review. In Sustainability (Switzerland) (Vol. 13, Issue 17). MDPI. https://doi.org/10.3390/su13179815
  8. He, Y., Chen, Y., Chen, Z., Deng, Z., & Yuan, Y. (2022). Impacts of Occupant Behavior on Building Energy Consumption and Energy Savings Analysis of Upgrading ASHRAE 90.1 Energy Efficiency Standards. Buildings, 12(8). https://doi.org/10.3390/buildings12081108
  9. Hörner, M., & Lichtmeß, M. (2019). Energy performance of buildings: A statistical approach to marry calculated demand and measured consumption. Energy Efficiency, 12(1), 139–155. https://doi.org/10.1007/s12053-018-9664-2
  10. Maciel, T. S., Cruz, A. S., Torres, M. C. A., & ... (2023). Multi-objective optimization of school building envelope for two distinct geometric designs in southern Brazil. Indoor and Built …. https://doi.org/10.1177/1420326X231180422
  11. Manimaran, V., Chacko, S., & Kumar, P. (2014). Performance Evaluation of Air-Cooled Screw Chillers at Low Part Load Ratios and Outdoor Temperatures in Dubai and Measures to Improve the Performance. International Journal of Smart Grid and Clean Energy. https://doi.org/10.12720/sgce.4.1.85-91
  12. Mazzaferro, L., Machado, R. M. S., Melo, A. P., & Lamberts, R. (2020). Do we need building performance data to propose a climatic zoning for building energy efficiency regulations? Energy and Buildings, 225, 110303. https://doi.org/10.1016/j.enbuild.2020.110303
  13. Ministry of Public Works and Housing. (2023). Peta Jalan Penyelenggaraan dan Pembinaan Bangunan Gedung Hijau (BGH)
  14. Niu, M., & and Leicht, R. M. (2016). Information exchange requirements for building walk-through energy audits. Science and Technology for the Built Environment, 22(3), 328–336. https://doi.org/10.1080/23744731.2016.1151713
  15. Pukhkal, V. (2021). Numerical Modeling of Energy Consumption in Residential Buildings. IOP Conference Series: Materials Science and Engineering, 1079(5), 052025. https://doi.org/10.1088/1757-899X/1079/5/052025
  16. Purnami, N. A., Arianti, R., & Setiawan, P. (2022). Analisis Intensitas Konsumsi Energi (IKE) pada Institut Teknologi Dirgantara Adisutjipto (ITDA) Yogyakarta. Aviation Electronics, 4(2), 225–240
  17. Puteri, D. S. (2024). Making Indonesia Sustainable: Shaping the Law to Reduce Digital Carbon Footprint. Indonesian Journal of Advocacy and Legal Services, 6(1), 77–102. https://doi.org/10.15294/ijals.v6i1.78500
  18. Röck, M., Saade, M. R. M., Balouktsi, M., Rasmussen, F. N., Birgisdottir, H., Frischknecht, R., Habert, G., Lützkendorf, T., & Passer, A. (2020). Embodied GHG emissions of buildings – The hidden challenge for effective climate change mitigation. Applied Energy, 258, 114107. https://doi.org/10.1016/j.apenergy.2019.114107
  19. Serag, H., Mahmoud, M., Kamel, T., & Fahmy, A. (2024). Comparative Validation of a Building Energy Model Calibration Methodology with a Focus on Residential Buildings. Civil Engineering and Architecture, 12(3), 1447–1462. https://doi.org/10.13189/cea.2024.120314
  20. Shari, Z., Mohamad, N. L., & Dahlan, N. D. (2023). Building Envelope Retrofit for Energy Savings in Malaysian Government High-Rise Offices: A Calibrated Energy Simulation. Jurnal Teknologi (Sciences & Engineering), 85(4), 1–15
  21. Sunikka-Blank, M., & Galvin, R. (2012). Introducing the prebound effect: The gap between performance and actual energy consumption. Building Research and Information, 40(3), 260–273. https://doi.org/10.1080/09613218.2012.690952
  22. Surahman, U., Kubota, T., & Higashi, O. (2015). Life cycle assessment of energy and CO2 emissions for residential buildings in Jakarta and Bandung, Indonesia. Buildings, 5(4), 1131–1155
  23. Suswitaningrum, E., Hudallah, N., Putri, R. D. M., & Sunarko, B. (2022). Analisis Intensitas Konsumsi Energi Listrik dan Peluang Penghematan Energi Listrik pada Gedung C Kantor Sekretariat Daerah Kabupaten Semarang. Jurnal ELTIKOM, 6(1), 26–39. https://doi.org/10.31961/eltikom.v6i1.545
  24. Tan, X. Y., Mahyuddin, N., & Zaid, S. M. (2023). Efficacy of Energy Conservation Measures and Building Energy Intensity of a Multi-Building Complex in Malaysia. E3S Web of Conferences, 396, 03004
  25. Vargas, A. C., & Hamui, L. (2021). Thermal Energy Performance Simulation of a Residential Building Retrofitted With Passive Design Strategies: A Case Study in Mexico. Sustainability. https://doi.org/10.3390/su13148064
  26. Yang, R., & Wang, L. (2015). Control Strategy Optimization for Energy Efficiency and Comfort Management in HVAC Systems. https://doi.org/10.1109/isgt.2015.7131863
  27. Yin, R. K. (2017). Case study research and applications: Design and methods. Sage publications

Last update:

No citation recorded.

Last update: 2025-07-06 13:02:11

No citation recorded.