Universitas Gadjah Mada, Indonesia
BibTex Citation Data :
@article{IJRED15086, author = {Siti Jamilatun and Budhijanto Budhijanto and Rochmadi Rochmadi and Arief Budiman}, title = {Thermal Decomposition and Kinetic Studies of Pyrolysis of Spirulina Platensis Residue}, journal = {International Journal of Renewable Energy Development}, volume = {6}, number = {3}, year = {2017}, keywords = {Spirulina platensis residue (SPR); Pyrolysis Thermal decomposition; Peak; Activation energy}, abstract = { Analysis of thermal decomposition and pyrolisis reaction kinetics of Spirulina platensis residue (SPR) was performed using Thermogravimetric Analyzer. Thermal decomposition was conducted with the heating rate of 10, 20, 30, 40 and 50 o C/min from 30 to 1000 o C. Thermogravimetric (TG), Differential Thermal Gravimetric (DTG), and Differential Thermal Analysis (DTA) curves were then obtained. Each of the curves was divided into 3 stages. In Stage I, water vapor was released in endothermic condition. Pyrolysis occurred in exothermic condition in Stage II, which was divided into two zones according to the weight loss rate, namely zone 1 and zone 2. It was found that gasification occurred in Stage III in endothermic condition. The heat requirement and heat release on thermal decomposition of SPR are described by DTA curve, where 3 peaks were obtained for heating rate 10, 20 and 30°C/min and 2 peaks for 40 and 50°C/min, all peaks present in Zone 2. As for the DTG curve, 2 peaks were obtained in Zone 1 for similar heating rates variation. On the other hand, thermal decomposition of proteins and carbohydrates is indicated by the presence of peaks on the DTG curve, where lignin decomposition do not occur due to the low lipid content of SPR (0.01wt%). The experiment results and calculations using one-step global model successfully showed that the activation energy (Ea) for the heating rate of 10, 20, 30, 40 and 50 o C/min for zone 1 were 35.455, 41.102, 45.702, 47.892 and 47.562 KJ/mol, respectively, and for zone 2 were 0.0001428, 0.0001240, 0.0000179, 0.0000100 and 0.0000096 KJ/mol, respectively. Keywords: Spirulina platensis residue (SPR), Pyrolysis, Thermal decomposition, Peak, Activation energy. Article History : Received June 15 th 2017; Received in revised form August 12 th 2017; Accepted August 20 th 2017; Available online How to Cite This Article : Jamilatun, S., Budhijanto, Rochmadi, and Budiman, A. (2017) Thermal Decomposition and Kinetic Studies of Pyrolysis of Spirulina platensis Residue, International Journal of Renewable Energy Development 6(3), 193-201. https://doi.org/10.14710/ijred.6.3.193-201 }, pages = {193--201} doi = {10.14710/ijred.6.3.193-201}, url = {https://ejournal.undip.ac.id/index.php/ijred/article/view/15086} }
Refworks Citation Data :
Analysis of thermal decomposition and pyrolisis reaction kinetics of Spirulina platensis residue (SPR) was performed using Thermogravimetric Analyzer. Thermal decomposition was conducted with the heating rate of 10, 20, 30, 40 and 50oC/min from 30 to 1000oC. Thermogravimetric (TG), Differential Thermal Gravimetric (DTG), and Differential Thermal Analysis (DTA) curves were then obtained. Each of the curves was divided into 3 stages. In Stage I, water vapor was released in endothermic condition. Pyrolysis occurred in exothermic condition in Stage II, which was divided into two zones according to the weight loss rate, namely zone 1 and zone 2. It was found that gasification occurred in Stage III in endothermic condition. The heat requirement and heat release on thermal decomposition of SPR are described by DTA curve, where 3 peaks were obtained for heating rate 10, 20 and 30°C/min and 2 peaks for 40 and 50°C/min, all peaks present in Zone 2. As for the DTG curve, 2 peaks were obtained in Zone 1 for similar heating rates variation. On the other hand, thermal decomposition of proteins and carbohydrates is indicated by the presence of peaks on the DTG curve, where lignin decomposition do not occur due to the low lipid content of SPR (0.01wt%). The experiment results and calculations using one-step global model successfully showed that the activation energy (Ea) for the heating rate of 10, 20, 30, 40 and 50oC/min for zone 1 were 35.455, 41.102, 45.702, 47.892 and 47.562 KJ/mol, respectively, and for zone 2 were 0.0001428, 0.0001240, 0.0000179, 0.0000100 and 0.0000096 KJ/mol, respectively.
Keywords: Spirulina platensis residue (SPR), Pyrolysis, Thermal decomposition, Peak, Activation energy.
Article History: Received June 15th 2017; Received in revised form August 12th 2017; Accepted August 20th 2017; Available online
How to Cite This Article: Jamilatun, S., Budhijanto, Rochmadi, and Budiman, A. (2017) Thermal Decomposition and Kinetic Studies of Pyrolysis of Spirulina platensis Residue, International Journal of Renewable Energy Development 6(3), 193-201.
https://doi.org/10.14710/ijred.6.3.193-201
Article Metrics:
Last update:
Rheological and kinetic studies of low density polyetyhlene (LDPE) – chitosan biocomposite film
Inorganic elemental composition analysis of Arthrospira platensis-Activated carbon blend at mass ratio of 10:1 for considering its thermal conversion characteristics
Moving towards Valorization of Biowastes Issued from Biotrickling Filtration of Contaminated Gaseous Streams: A Thermochemical Analysis-Based Perspective
Advances in Manufacturing IV
Bio-Oil Characterizations of Spirulina Platensis Residue (SPR) Pyrolysis Products for Renewable Energy Development
Conversion of bio-coke from Spirulina platensis microalgae as an alternative sustainable energy
Co-pyrolysis of empty fruit bunches impregnated with Ni and lignite into liquid oil
Conversion of bio-coke from microalgae as a potential strategy for double fuel technology
Thermogravimetric Analysis and Kinetic Study on Catalytic Pyrolysis of Rice Husk Pellet using Its Ash as a Low-cost In-situ Catalyst
Characterization of Microalgae Biomass-Based Composites Obtained through Rotational Molding
Kinetic Study of Copyrolysis of the Green Microalgae Botryococcus braunii and Victorian Brown Coal by Thermogravimetric Analysis
Catalytic Co-Pyrolysis of Palm Oil Empty Fruit Bunch and Coal into Liquid Oil
Catalytic and non−catalytic pyrolysis of Spirulina platensis residue (SPR): Effects of temperature and catalyst content on bio-oil yields and its composition
Last update: 2024-12-23 16:43:22
Effects of temperature and catalysts on the yield of bio-oil during the pyrolysis of Spirulina platensis residue
Rheological and kinetic studies of low density polyetyhlene (LDPE) - Chitosan biocomposite film
Ex-situ catalytic upgrading of Spirulina platensis residue oil using silica alumina catalyst
Catalytic pyrolysis of spirulina platensis residue (SPR): Thermochemical behavior and kinetics
Effect Of Grain Size, Temperature And Catalyst Amount On Pyrolysis Products Of Spirulina Platensis Residue (Spr)
Non-catalytic and Catalytic Pyrolysis of Spirulina platensis residue (SPR) in Fixed-Bed Reactors: Characteristic and Kinetic Study with Primary and Secondary Tar Cracking Models
Catalytic and noncatalytic pyrolysis of spirulina platensis residue (spr): Effects of temperature and catalyst content on bio-oil yields and its composition
In situ resource utilization - Analogues for a lunar constructed magnetron via 3D printing and microwave casting
Bio-oil characterizations of spirulina platensis residue (Spr) pyrolysis products for renewable energy development
This journal provides immediate open access to its content on the principle that making research freely available to the public supports a greater global exchange of knowledge. Articles are freely available to both subscribers and the wider public with permitted reuse.
All articles published Open Access will be immediately and permanently free for everyone to read and download. We are continuously working with our author communities to select the best choice of license options: Creative Commons Attribution-ShareAlike (CC BY-SA). Authors and readers can copy and redistribute the material in any medium or format, as well as remix, transform, and build upon the material for any purpose, even commercially, but they must give appropriate credit (cite to the article or content), provide a link to the license, and indicate if changes were made. If you remix, transform, or build upon the material, you must distribute your contributions under the same license as the original.
International Journal of Renewable Energy Development (ISSN:2252-4940) published by CBIORE is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.