Energy-Exergy Analysis of A Novel Multi-Pass Solar Air Collector With Perforated Fins

DOI: https://doi.org/10.14710/ijred.8.1.47-55
Cover Image

Article Metrics: (Click on the Metric tab below to see the detail)

Article Info
Published: 02-02-2019
Section: Original Research Article
Fulltext PDF Tell your colleagues Email the author

This work presents performance analysis of a novel multi-pass solar air collector with perforated fins (MPSACF) in winter conditions, Ankara province, Turkey. The aim of this work is to experimentally test  and compare the performance of the two different design of solar collectors in the same climatic conditions.  In addition, a double-pass solar air collector without fins (DPSAC) at the same absorber area was manufactured and tested as a control group. The total absorber area of both solar collectors is 0.325 m2. Thermal effects for performance improvement of the collectors have been designated.  Average thermal efficiency values of DPSAC and MPSACF were calculated as 47.85% and 51.86%, 67.10% and 72.86%, respectively in experiments performed at 0.0069 kg/s (0.7 m/s air velocity) and 0.0087 kg/s (0.9 m/s air velocity) mass flow rates. Exergy efficiency of DPSAC and MPSACF were 2.10-17.12% and 8.74-23.97%, respectively. Coefficient of performance(COP) values were ocomputed 4.63 and 4.94, 3.18 and 3.48 respectively in experiments performed at 0.0069 kg/s and 0.0087 kg/s mass flow rates. Although the MPSACF has high efficiency values, COP values are lower due to the presence of dual fans. Because of their high thermal efficiency, both collectors can be effectively practiced for applications such as preheating, space heating and ventilation, greenhouse heating and product drying

©2019. CBIORE-IJRED. All rights reserved

Article History: Received May 16th 2018; Received in revised form October 16th 2018 ; Accepted January 6th 2019; Available online

How to Cite This Article: Aktaş, M., Sözen, A., Tuncer, A.D., Arslan, E., Koşan, M., Çürük, O. (2019) Energy-exergy analysis of a novel multi-pass solar air collector with perforated fins. International Journal of Renewable Energy Development, 8(1), 47-55.

http://dx.doi.org/10.14710/ijred.8.1.47-55

 

Keywords

Solar energy; solar collector efficiency; energy and exergy; multi-pass solar air collector; performance analysis

  1. Mustafa Aktaş 
    Energy Systems Engineering, Technology Faculty, Gazi University, Ankara, Turkey
  2. Adnan Sözen 
    Energy Systems Engineering, Technology Faculty, Gazi University, Ankara, Turkey
  3. Azim Doğuş Tuncer 
    Energy Systems Engineering, Faculty of Engineering-Architecture, Burdur Mehmet Akif Ersoy University, Burdur, Turkey
  4. Erhan Arslan 
    Insitute of Natural and Applied Science, Gazi University, Ankara,, Turkey
  5. Meltem Koşan 
    Energy Systems Engineering, Technology Faculty, Gazi University, Ankara, Turkey
  6. Osman Çürük 
    Energy Systems Engineering, Technology Faculty, Gazi University, Ankara, Turkey
  1. Abuşka, M. & Şevik, S. (2017) Energy, exergy, economic and environmental (4E) analyses of flat-plate and V-groove solar air collectors based on aluminium and copper. Solar Energy, 158, 259-277.
  2. Aktaş, M., Sözen, A., Amini, A. & Khanlari, A. (2017) Experimental Analysis and CFD Simulation of Infrared Apricot Dryer with Heat Recovery. Drying Technolgy, 35(6), 766–783.
  3. Aktaş, M., Şevik, S., Dolgun, E.C. & Demirci, B. (2018) Drying of grape pomace with a double pass solar collector. Drying Technology, 1-13.
  4. Alta, Z.D., Çağlayan, N., Ezan, M.A. & Ertekin, C. (2015) Thermal analysis of a solar air heater for drying purposes. Agricultural Engineering International, 193-199.
  5. Azaizia, Z., Kooli, S., Elkhadraoui, A., Hamdi, I., Guizani, A. (2017) Investigation of a new solar greenhouse drying system for peppers. International Journal of Hydrogen Energy, 42, 8818-8826.
  6. Blowmik, H. & Amin, R. (2017) Efficiency improvement of flat plate solar collector using reflector. Energy Report, 3, 119-123.
  7. Cengel, Y.A. & Ghajar, A.J. (2011) Heat and Mass Transfer: Fundamentals and Applications Fourth Edition in SI Units. McGraw-Hill, New York.
  8. Devecioglu, A.G. & Oruc, V. (2017) Experimental investigation of thermal performance of a new Solar air collector with porous surface. Energy Procedia, 113, 251-258.
  9. Fudholi, A., Sopian, K., Ruslan, M.H. &Othman, M.Y. (2013) Performance and cost benefits analysis of double-pass solar collector with and without fins. Energy Conversion and Management, 76, 8-19.
  10. Ghiami, A. & Ghiami, S. (2018) Comparative study based on energy and exergy analyses of a baffled solar air heater with latent storage collector. Applied Thermal Engineering, 133, 797-808.
  11. Gill, R.S., Singh, S. & Singh, P.P. (2013) Low cost solar air heater. Energy Conversion and Management, 57, 131–142.
  12. Hernández, A.L. & Quiñonez, J.E. (2018) Experimental validation of an analytical model for performance estimation of natural convection solar air heating collectors. Renewable Energy, 117, 202-216.
  13. Hosseini, S.S., Ramiar, A. & Ranjbar, A.A. (2018) Numerical investigation of natural convection solar air heater with different fins shape. Renewable Energy, 117, 488-500.
  14. Kareem, M.W., Gilani, I., Habib, K., Irshad, K. & Baran Saha, B. (2017) Performance analysis of a multi-pass solar thermal collector system under transient state assisted by porous media. Solar Energy, 158, 782-791.
  15. Karim, M.A., Perez, E. & Amin, Z.Y. (2014) Mathematical modelling of counter flow v-grove solar air collector. Renewable Energy, 67, 192-201.
  16. Kays, W.M. (1966) Convective Heat and Mass Transfer. McGraw-Hill, New York.
  17. Klein, S.A. (1975) Calculation of flat plate collector loss coefficients. Solar Energy, 17, 79-80.
  18. Lesny, J., Panfil, M., Urbaniak, M. (2018) Influence of irradiance and irradiation on characteristic parameters for solar air collector prototype. Solar Energy, 164, 224-230.
  19. Naphon, P. (2005) On the performance and entropy generation of the double-pass solar air heater with longitudinal fins. Renewable Energy, 30(9), 1345-1357.
  20. Olimat, A.N. (2017) Study of Fabricated Solar Dryer of Tomato Slices Under Jordan Climate Condition. International Journal of Renewable Energy Development, 6(2), 93-101.
  21. Othman, M.Y.H., Yatima, B., Sopian, K. & Abu Bakara, M.N. (2005) Performance analysis of a double-pass photovoltaic/thermal (PV/T) solar collector with CPC and fins. Renewable Energy, 30, 2005–2017.
  22. Ozgen, F., Esen, M. & Esen, H. (2009) Experimental investigation of thermal performance of a double-flow solar air heater having aluminium cans. Renewable Energy, 34, 2391–2398.
  23. Priyam, A. & Chand, P. (2018) Effect of wavelength and amplitude on the performance of wavy finned absorber solar air heater. Renewable Energy, 119, 690-702.
  24. Saxena, A., Varun & El-Sebaii, A.A. (2015) A thermodynamic review of solar air heaters. Renewable and Sustainable Energy Reviews, 43, 863-890.
  25. Şevik, S. (2013) Design, experimental investigation and analysis of a solar drying system. Energy Conversion and Management, 68, 227-234.
  26. Tiwari, S. & Tiwari, G.N. (2017) Energy and exergy analysis of a mixed-mode greenhouse-type solar dryer, integrated with partially covered N-PVT air collector. Energy, 128, 183-195.
  27. Zare, D., Minaei, S., Mohamad Zadeh, M. & Khoshtaghaza, M.H. (2006)Computer simulation of rough rice drying in a batch dryer. Energy Conversion and Management, 47, 3241-3254.
  28. Zheng, W., Zhang, H., You, S., Fu, Y. & Zheng, X. (2017) Thermal performance analysis of a metal corrugated packing solar air collector in cold regions. Applied Energy, 203, 938-947.