Department of Electrical and Electronics Engineering, Amrita School of Engineering, Bengaluru, Amrita Vishwa Vidyapeetham, India
BibTex Citation Data :
@article{IJRED34484, author = {Thiruvonasundari Duraisamy and Kaliyaperumal Deepa}, title = {Evaluation and Comparative Study of Cell Balancing Methods for Lithium-Ion Batteries Used in Electric Vehicles}, journal = {International Journal of Renewable Energy Development}, volume = {10}, number = {3}, year = {2021}, keywords = {Electric vehicle; Lithium-ion battery; Energy efficiency; Temperature behaviour and Cost analysis}, abstract = { Vehicle manufacturers positioned electric vehicles (EVs) and hybrid electric vehicles (HEVs) as reliable, safe and environmental friendly alternative to traditional fuel based vehicles. Charging EVs using renewable energy resources reduce greenhouse emissions. The Lithium-ion (Li-ion) batteries used in EVs are susceptible to failure due to voltage imbalance when connected to form a pack. Hence, it requires a proper balancing system categorised into passive and active systems based on the working principle. It is the prerogative of a battery management system (BMS) designer to choose an appropriate system depending on the application. This study compares and evaluates passive balancing system against widely used inductor based active balancing system in order to select an appropriate balancing scheme addressing battery efficiency and balancing speed for E-vehicle segment (E-bike, E-car and E-truck). The balancing systems are implemented using “top-balancing” algorithm which balance the cells voltages near the end of charge for better accuracy and effective balancing. The most important characteristics of the balancing systems such as degree of imbalance, power loss and temperature variation are determined by their influence on battery performance and cost. To enhance the battery life, Matlab-Simscape simulation-based analysis is performed in order to fine tune the cell balancing system for the optimal usage of the battery pack. For the simulation requirements, the battery model parameters are obtained using least-square fitting algorithm on the data obtained through electro chemical impedance spectroscopy (EIS) test. The achieved balancing time of the passive and active cell balancer for fourteen cells were 48 and 20 min for the voltage deviation of 30 mV. Also, the recorded balancing time was 215 and 42 min for the voltage deviation of 200 mV. }, pages = {471--479} doi = {10.14710/ijred.2021.34484}, url = {https://ejournal.undip.ac.id/index.php/ijred/article/view/34484} }
Refworks Citation Data :
Vehicle manufacturers positioned electric vehicles (EVs) and hybrid electric vehicles (HEVs) as reliable, safe and environmental friendly alternative to traditional fuel based vehicles. Charging EVs using renewable energy resources reduce greenhouse emissions. The Lithium-ion (Li-ion) batteries used in EVs are susceptible to failure due to voltage imbalance when connected to form a pack. Hence, it requires a proper balancing system categorised into passive and active systems based on the working principle. It is the prerogative of a battery management system (BMS) designer to choose an appropriate system depending on the application. This study compares and evaluates passive balancing system against widely used inductor based active balancing system in order to select an appropriate balancing scheme addressing battery efficiency and balancing speed for E-vehicle segment (E-bike, E-car and E-truck). The balancing systems are implemented using “top-balancing” algorithm which balance the cells voltages near the end of charge for better accuracy and effective balancing. The most important characteristics of the balancing systems such as degree of imbalance, power loss and temperature variation are determined by their influence on battery performance and cost. To enhance the battery life, Matlab-Simscape simulation-based analysis is performed in order to fine tune the cell balancing system for the optimal usage of the battery pack. For the simulation requirements, the battery model parameters are obtained using least-square fitting algorithm on the data obtained through electro chemical impedance spectroscopy (EIS) test. The achieved balancing time of the passive and active cell balancer for fourteen cells were 48 and 20 min for the voltage deviation of 30 mV. Also, the recorded balancing time was 215 and 42 min for the voltage deviation of 200 mV.
Article Metrics:
Last update:
Proceedings of Congress on Control, Robotics, and Mechatronics
Proceedings of the 12th International Conference on Soft Computing for Problem Solving
A Review on Environmental Efficiency Evaluation of New Energy Vehicles Using Life Cycle Analysis
Reduced graphene oxide composite aerogels for lithium-ion batteries
Modular Lithium-Ion Cell Battery Management System with High Current Balancing
Development of Hybrid PV Wind system for EVs with Battery Management System
Proceedings of the UNIfied Conference of DAMAS, IncoME and TEPEN Conferences (UNIfied 2023)
A Comparative Analysis of Power Generation Using Solar and Fuel Cell for Charging EVs
Analyzing the mechanism of performance improvement in LiNi0.8Co0.1Mn0.1O2 through coating with LiNbO3 fast ion conductor
Utilization of the spent catalyst as a raw material for rechargeable battery production: The effect of leaching time, type, and concentration of organic acids
Effect of Fast Charging on Lithium-Ion Batteries: A Review
A Novel Proportional Integral Controller Based Passive Cell Balancing for Battery Management System
A Novel Online State of Health Estimation Method for Electric Vehicle Pouch Cells Using Magnetic Field Imaging and Convolution Neural Networks
A Review on Power Electronic Converters for Modular BMS with Active Balancing
Machine Learning-Based Optimal Cell Balancing Mechanism for Electric Vehicle Battery Management System
Last update: 2024-11-11 20:00:02
This journal provides immediate open access to its content on the principle that making research freely available to the public supports a greater global exchange of knowledge. Articles are freely available to both subscribers and the wider public with permitted reuse.
All articles published Open Access will be immediately and permanently free for everyone to read and download. We are continuously working with our author communities to select the best choice of license options: Creative Commons Attribution-ShareAlike (CC BY-SA). Authors and readers can copy and redistribute the material in any medium or format, as well as remix, transform, and build upon the material for any purpose, even commercially, but they must give appropriate credit (cite to the article or content), provide a link to the license, and indicate if changes were made. If you remix, transform, or build upon the material, you must distribute your contributions under the same license as the original.
International Journal of Renewable Energy Development (ISSN:2252-4940) published by CBIORE is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.