Chemistry Department, Faculty of Sciences and Mathematics, Diponegoro University, Jl. Prof. Soedarto, SH., Tembalang, Semarang, Indonesia
BibTex Citation Data :
@article{JKSA81742, author = {Umi Shofiyatun Ni’mah and Kamilia Hijriani Zain and Ngadiwiyana Ngadiwiyana and Purbowatiningrum Ria Sarjono and Ismiyarto Ismiyarto}, title = {Synthesis of Polyethylene Glycol-Modified Salicylaldehyde–Chitosan Schiff Base and Its Antibacterial Assay}, journal = {Jurnal Kimia Sains dan Aplikasi}, volume = {29}, number = {4}, year = {2026}, keywords = {Chitosan; Schiff base; Salicylaldehyde; Polyethylene glycol; Crosslinking; Antibacterial activity}, abstract = { Antibacterial materials are essential for inhibiting the growth of pathogenic microorganisms, and chitosan has received considerable attention due to its intrinsic antibacterial properties, biocompatibility, and biodegradability. However, the limited hydrophilicity and moderate mechanical strength of pristine chitosan restrict its broader application. In this study, chitosan was chemically modified through Schiff base formation with salicylaldehyde, followed by modification with polyethylene glycol (PEG), to enhance its physicochemical properties while maintaining detectable antibacterial performance. The objectives of this research were to synthesize Salicylaldehyde–chitosan Schiff base and PEG-modified Salicylaldehyde–chitosan Schiff base, to characterize their structural and physical properties, and to evaluate their antibacterial performance. The molecular weight of chitosan was determined by viscometry, and the degree of deacetylation was evaluated by Fourier transform infrared (FTIR) spectroscopy. The chitosan used exhibited a molecular weight of 147,926 g/mol and a degree of deacetylation of 67%. Schiff base formation was carried out by refluxing chitosan with salicylaldehyde at 60°C for 3 hours, using various molar ratios. The highest degree of substitution (68.75%) and yield (41.08%) were obtained, with the moderate yield attributed to incomplete conversion and material loss during purification steps. Structural confirmation was achieved through FTIR and UV–Vis spectroscopy by the appearance of characteristic imine (C=N) absorption bands. Subsequent modification with PEG at room temperature for 24 hours yielded 40.49%. The PEG-modified material exhibited significantly enhanced hydrophilicity, as indicated by a swelling ratio of 333.33% and a reduced contact angle of 63.04°. Antibacterial activity evaluated by the disc diffusion method showed inhibition zones of 9 mm against Escherichia coli and 10 mm against Staphylococcus aureus , which are modestly higher than those of the solvent control under the tested conditions. These results suggest that PEG modification improves the hydrophilicity of the chitosan-based Schiff base material while maintaining measurable antibacterial activity, indicating potential for further development in antimicrobial and biomedical materials. }, issn = {2597-9914}, pages = {252--264} doi = {10.14710/jksa.29.4.252-264}, url = {https://ejournal.undip.ac.id/index.php/ksa/article/view/81742} }
Refworks Citation Data :
Antibacterial materials are essential for inhibiting the growth of pathogenic microorganisms, and chitosan has received considerable attention due to its intrinsic antibacterial properties, biocompatibility, and biodegradability. However, the limited hydrophilicity and moderate mechanical strength of pristine chitosan restrict its broader application. In this study, chitosan was chemically modified through Schiff base formation with salicylaldehyde, followed by modification with polyethylene glycol (PEG), to enhance its physicochemical properties while maintaining detectable antibacterial performance. The objectives of this research were to synthesize Salicylaldehyde–chitosan Schiff base and PEG-modified Salicylaldehyde–chitosan Schiff base, to characterize their structural and physical properties, and to evaluate their antibacterial performance. The molecular weight of chitosan was determined by viscometry, and the degree of deacetylation was evaluated by Fourier transform infrared (FTIR) spectroscopy. The chitosan used exhibited a molecular weight of 147,926 g/mol and a degree of deacetylation of 67%. Schiff base formation was carried out by refluxing chitosan with salicylaldehyde at 60°C for 3 hours, using various molar ratios. The highest degree of substitution (68.75%) and yield (41.08%) were obtained, with the moderate yield attributed to incomplete conversion and material loss during purification steps. Structural confirmation was achieved through FTIR and UV–Vis spectroscopy by the appearance of characteristic imine (C=N) absorption bands. Subsequent modification with PEG at room temperature for 24 hours yielded 40.49%. The PEG-modified material exhibited significantly enhanced hydrophilicity, as indicated by a swelling ratio of 333.33% and a reduced contact angle of 63.04°. Antibacterial activity evaluated by the disc diffusion method showed inhibition zones of 9 mm against Escherichia coli and 10 mm against Staphylococcus aureus, which are modestly higher than those of the solvent control under the tested conditions. These results suggest that PEG modification improves the hydrophilicity of the chitosan-based Schiff base material while maintaining measurable antibacterial activity, indicating potential for further development in antimicrobial and biomedical materials.
Article Metrics:
Last update:
Last update: 2026-05-31 12:56:55
As an article writer, the author has the right to use their articles for various purposes, including use by institutions that employ authors or institutions that provide funding for research. Author rights are granted without special permission.
Author who publishes a paper at JKSA has the broad right to use their work for teaching and scientific purposes without the need to ask permission, including: used for (i) teaching in the author's class or institution, (ii) presentation at meetings or conferences and distributing copies to participants ; (iii) training conducted by the author or author's institution; (iv) distribution to colleagues for research use; (v) use in the compilation of subsequent authors' works; (vi) inclusion in a thesis or dissertation; (vi) reuse of part of the article in another work (with citation); (vii) preparation of derivative works (with citation); (viii) voluntary posting on open websites operated by authors or author institutions for scientific purposes (follow the CC BY-SA License).
Authors and readers can copy and redistribute material in any media or format, and mix, modify, and build material for any purpose but they must provide appropriate credit (provide article citation or content), providing links to the license, and indicate if there are changes.
The authors submitting a manuscript do so on the understanding that if accepted for publication, copyright of the article shall be assigned to Jurnal Kimia Sains dan Aplikasi (JKSA). Copyright encompasses rights to reproduce and deliver the article in all form and media, including reprints, photographs, microfilms and any other similar reproductions, as well as translations.
Reproduce any part of this journal, its storage in the database or its transmission by all forms or media is permitted does not need for written permission from JKSA. However, it should be cited as an honor in academic manners
JKSA and the Chemistry Department of Diponegoro University and the Editor make every effort to ensure that there are no data, opinions, or false or misleading statements published in JKSA. However, the content of the article is the sole and exclusive responsibility of each author.
The Copyright Transfer Form can be downloaded here: [Copyright Transfer Form - Indonesian] [Copyright Transfer Form - English]. The copyright form should be signed originally and send to the Editor in the form of printed letters, scanned documents sent via email or fax.
Adi Darmawan, Ph.D (Editor in Chief)
Editor in chief of Jurnal Kimia Sains dan Aplikasi (JKSA)
Chemistry Department, Faculty of Sciences and Mathematics, Diponegoro University
Visitor: View My Stats
Jurnal Kimia Sains dan Aplikasi is indexed in:
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.