DOI: https://doi.org/10.14710/reaktor.18.04.177-182

Effect of pH and Gas Flow Rate on Ozone Mass Transfer of Κ-Carrageenan Solution in Bubble Column Reactor

*Aji Prasetyaningrum  -  Diponegoro University, Indonesia
Dyah Arum Kusumaningtyas  -  Diponegoro University, Indonesia
Purbo Suseno  -  Diponegoro University, Indonesia
Ratnawati Ratnawati  -  Diponegoro University, Indonesia
Received: 29 Sep 2017; Published: 31 Mar 2019.
Open Access Copyright (c) 2019 Reaktor under http://creativecommons.org/licenses/by-nc-sa/4.0.

Citation Format:
Abstract

This research was conducted to calculate the mass transfer coefficient value for ozonation reaction of κ-carrageenan solution in the bubble column reactor. Ozone gas was produced using ozone generator type corona discharge. In this study, operating conditions were regulated at ozone gas flow rate 2- 5 L min-1, pH 4-10, and temperature 29 ± 1 oC. Samples were tested every 5 minutes to determine the dissolved ozone concentration. The results showed that dissolved ozone concentrations increased with increasing ozonation time and ozone gas flow rate. However, a very high gas flow rate can increase turbulence so that the mass transfer coefficient (kLa) value decreased. In alkaline conditions, the formation of free radicals (HO*) increases so that the amount of dissolved ozone decreases. The kLa value of ozone gas in κ-carrageenan solution is slightly lower than the kLa value of the ozone gas in the water. The results of this study indicate that (kLa) ozone gas in water is 0.131 / minute while the value (kLa) in κ-carrageenan solution is 0.128 / minute.


Keywords: ozone; mass transfer; pH; flowrate

Note: This article has supplementary file(s).

Fulltext View|Download |  Research Instrument
Untitled
Subject
Type Research Instrument
  Download (507KB)    Indexing metadata

Article Metrics:

Article Info
Section: Research Article
Language : EN
Recent articles
Front Matters Effect of Peanut Shell Torrefaction on Qualities of The Produced Bio-pellet Synthesis of Surfactant Tert-Butyl Glycosides from Glucose and Tert-Butanol Evaluation Performance of Pneumatic Dryer for Cassava Starch Back Matters More recent articles
Most cited articles
NON-DISSOLVED SOLIDS REMOVAL DURING PALM KERNEL OIL ULTRAFILTRATION THE PROPERTIES OF CHARCOAL FROM THE BLACK LIQUOR OF THE SODA PULPING OF RICE STRAW REAKSI KATALITIS ESTERIFIKASI ASAM OLEAT DAN METANOL MENJADI BIODIESEL DENGAN METODE DISTILASI REAKTIF APLIKASI SORBITOL PADA PRODUKSI BIODEGRADABLE FILM DARI NATA DE CASSAVA Lactic Acid Production From Cocoa Pod Husk by Studying Further the Influence of Alkaloids on Fermentation Process using Lactobacillus Plantarum Bacteria More cited articles

Last update:

  1. Wind Tunnel Testing of Plasma Actuator with Two Mesh Electrodes to Boundary Layer Control at High Angle of Attack

    Ernest Gnapowski, Jarosław Pytka, Jerzy Józwik, Jan Laskowski, Joanna Michałowska. Sensors, 21 (2), 2021. doi: 10.3390/s21020363

  2. Industrial Microbiology and Biotechnology

    Allwyn Vyas Gopalakrishnan, Harykrishnan Suresh, Ganapathy Mariappan, Abinaya Kanagaraja, Pachaiappan Raman. 2024. doi: 10.1007/978-981-97-6270-5_4

  3. Integrated Process for High Phenol Removal from Wastewater Employing a ZnO Nanocatalyst in an Ozonation Reaction in a Packed Bubble Column Reactor

    Adnan K. Majhool, Khalid A. Sukkar, May A. Alsaffar, Hasan Shakir Majdi. ChemEngineering, 7 (6), 2023. doi: 10.3390/chemengineering7060112

  4. Degradation of organic/inorganic pollutants through photofenton membrane bioreactor (PFMBR) and lumped kinetic modeling in pharmaceutical effluent

    Naveen Kumar S, Jothi Ramalingam R, Muthusamy Karnan, Kavitha N P. Chemical Engineering and Processing - Process Intensification, 185 , 2023. doi: 10.1016/j.cep.2023.109305

  5. Effect UV irradiation and ozonation(O3) process for degradation of copper from electroplating wastewater

    Aji Prasetyaningrum, Dessy Ariyanti, Hantoro Satriadi, S. Suherman, P. Purwanto, Bambang Pramudono, G. R. Prinanda. PROCEEDINGS OF 2ND INTERNATIONAL CONFERENCE ON CHEMICAL PROCESS AND PRODUCT ENGINEERING (ICCPPE) 2019, 2197 , 2020. doi: 10.1063/1.5140954

Last update: 2024-11-20 13:14:02

No citation recorded.