1Department of Chemical Engineering, Malikussaleh University, Lhokseumawe 24355, Indonesia
2Department of Civil Engineering, Malikussaleh University, Lhokseumawe 24355, Indonesia
3Department of Chemical Engineering, Jambi University, Muaro Jambi 36364, Indonesia
BibTex Citation Data :
@article{JKSA83028, author = {Raudhatul Ulfa and Firda Tirta Yani and Gita Nurma Yunita and Faisal Faisal and Misbul Hadi and Chindy Mauliza Duana and Wiza Ulfa Fibarzi}, title = {Recovery of Slow-Release Fertilizer from Tofu Wastewater via Magnesium Ammonium Phosphate (Struvite) Precipitation: Effect of pH and Molar Ratio}, journal = {Jurnal Kimia Sains dan Aplikasi}, volume = {29}, number = {6}, year = {2026}, keywords = {Struvite; Tofu wastewater; Phosphate removal; Slow-release fertilizer}, abstract = { Tofu wastewater contains high concentrations of phosphate (PO 4 3− ) and ammonium (NH 4 + ), which can cause eutrophication if discharged without proper treatment. One promising method for nutrient recovery and wastewater remediation is struvite (MgNH 4 PO 4 ·6H 2 O) precipitation, which simultaneously removes phosphate and produces a slow-release fertilizer. This study investigates the effect of pH variation (8, 9, and 10) and molar ratios of Mg 2+ :NH 4 + :PO 4 3− (1:1:1, 4:1:1, and 1:4:1) on phosphate removal efficiency, product yield, and morphological characteristics of the formed crystals. Experiments were conducted with a reaction time of 60 minutes under controlled pH conditions. The results revealed that both pH and molar ratio significantly affected the phosphate precipitation process. The highest phosphate removal efficiency of 89.94% was obtained at pH 9 with a 4:1:1 molar ratio, indicating that excess Mg 2+ under moderately alkaline conditions favored struvite formation. In contrast, the highest calculated product yield was observed at pH 8, showing that the condition giving maximum mass-based recovery was not identical to the condition giving maximum phosphate removal efficiency. At pH 10, phosphate removal efficiency decreased, most likely due to the formation of competing Mg(OH) 2 precipitates, which reduced the availability of free Mg 2+ for struvite crystallization. Scanning Electron Microscope (SEM) and X-ray Diffraction (XRD) analysis showed that the struvite crystals exhibited block-like morphologies with irregular surfaces and an average size of 20–50 μm. Although nutrient-release kinetics were not directly measured in this study, the observed crystal size may influence dissolution behavior based on the surface-area effect reported in the literature, supporting the potential application of the recovered struvite as a slow-release fertilizer. Overall, the findings demonstrate that pH 9 and the molar ratio of 4:1:1 represent the optimal conditions for struvite production from tofu wastewater, offering an environmentally sustainable approach to nutrient recovery and contributing to circular economy practices in agriculture. }, issn = {2597-9914}, pages = {405--413} doi = {10.14710/jksa.29.6.405-413}, url = {https://ejournal.undip.ac.id/index.php/ksa/article/view/83028} }
Refworks Citation Data :
Tofu wastewater contains high concentrations of phosphate (PO43−) and ammonium (NH4+), which can cause eutrophication if discharged without proper treatment. One promising method for nutrient recovery and wastewater remediation is struvite (MgNH4PO4·6H2O) precipitation, which simultaneously removes phosphate and produces a slow-release fertilizer. This study investigates the effect of pH variation (8, 9, and 10) and molar ratios of Mg2+:NH4+:PO43− (1:1:1, 4:1:1, and 1:4:1) on phosphate removal efficiency, product yield, and morphological characteristics of the formed crystals. Experiments were conducted with a reaction time of 60 minutes under controlled pH conditions. The results revealed that both pH and molar ratio significantly affected the phosphate precipitation process. The highest phosphate removal efficiency of 89.94% was obtained at pH 9 with a 4:1:1 molar ratio, indicating that excess Mg2+ under moderately alkaline conditions favored struvite formation. In contrast, the highest calculated product yield was observed at pH 8, showing that the condition giving maximum mass-based recovery was not identical to the condition giving maximum phosphate removal efficiency. At pH 10, phosphate removal efficiency decreased, most likely due to the formation of competing Mg(OH)2 precipitates, which reduced the availability of free Mg2+ for struvite crystallization. Scanning Electron Microscope (SEM) and X-ray Diffraction (XRD) analysis showed that the struvite crystals exhibited block-like morphologies with irregular surfaces and an average size of 20–50 μm. Although nutrient-release kinetics were not directly measured in this study, the observed crystal size may influence dissolution behavior based on the surface-area effect reported in the literature, supporting the potential application of the recovered struvite as a slow-release fertilizer. Overall, the findings demonstrate that pH 9 and the molar ratio of 4:1:1 represent the optimal conditions for struvite production from tofu wastewater, offering an environmentally sustainable approach to nutrient recovery and contributing to circular economy practices in agriculture.
Article Metrics:
Last update:
As an article writer, the author has the right to use their articles for various purposes, including use by institutions that employ authors or institutions that provide funding for research. Author rights are granted without special permission.
Author who publishes a paper at JKSA has the broad right to use their work for teaching and scientific purposes without the need to ask permission, including: used for (i) teaching in the author's class or institution, (ii) presentation at meetings or conferences and distributing copies to participants ; (iii) training conducted by the author or author's institution; (iv) distribution to colleagues for research use; (v) use in the compilation of subsequent authors' works; (vi) inclusion in a thesis or dissertation; (vi) reuse of part of the article in another work (with citation); (vii) preparation of derivative works (with citation); (viii) voluntary posting on open websites operated by authors or author institutions for scientific purposes (follow the CC BY-SA License).
Authors and readers can copy and redistribute material in any media or format, and mix, modify, and build material for any purpose but they must provide appropriate credit (provide article citation or content), providing links to the license, and indicate if there are changes.
The authors submitting a manuscript do so on the understanding that if accepted for publication, copyright of the article shall be assigned to Jurnal Kimia Sains dan Aplikasi (JKSA). Copyright encompasses rights to reproduce and deliver the article in all form and media, including reprints, photographs, microfilms and any other similar reproductions, as well as translations.
Reproduce any part of this journal, its storage in the database or its transmission by all forms or media is permitted does not need for written permission from JKSA. However, it should be cited as an honor in academic manners
JKSA and the Chemistry Department of Diponegoro University and the Editor make every effort to ensure that there are no data, opinions, or false or misleading statements published in JKSA. However, the content of the article is the sole and exclusive responsibility of each author.
The Copyright Transfer Form can be downloaded here: [Copyright Transfer Form - Indonesian] [Copyright Transfer Form - English]. The copyright form should be signed originally and send to the Editor in the form of printed letters, scanned documents sent via email or fax.
Adi Darmawan, Ph.D (Editor in Chief)
Editor in chief of Jurnal Kimia Sains dan Aplikasi (JKSA)
Chemistry Department, Faculty of Sciences and Mathematics, Diponegoro University
Visitor: View My Stats
Jurnal Kimia Sains dan Aplikasi is indexed in:
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
