1Centre for Energy Studies, Bangladesh University of Engineering and Technology, Dhaka, Bangladesh, Bangladesh
2Department of Mechanical Engineering, Vrije Universiteit Brussel, 1050 Brussels, Belgium, Bangladesh
3Department of Mechanical Engineering, Vrije Universiteit Brussel, 1050 Brussels, Belgium, Belgium
BibTex Citation Data :
@article{IJRED18359, author = {Md. Obaidullah and Svend Bram and Jacques De Ruyck De Ruyck}, title = {Investigation on Gaseous and Particle Mass Emissions from Automatically Fired Small Scale Heating System under Laboratory Conditions}, journal = {International Journal of Renewable Energy Development}, volume = {7}, number = {2}, year = {2018}, keywords = {Pellet stove; combustion cycle;gaseous emissions; particle mass emissions; performance analysis}, abstract = { This study presents the experimental results on gaseous and particle mass emissions obtained from a bottom feed pellet stove of 2.5 kW output in part load heat and 5 kW output in nominal heat. The experiments were conducted in a stove manufacturing plant in the southern part of Belgium. Two combustion experiments (A and B) in part load heat output and four experiments (C, D, E and E) in nominal load were performed at three combustion phases: startup, combustion and burnout phase. The pellet stove was operated in different fan speeds varied from 900 rpm to 1250 rpm for the combustion experiments. Experiments A and B were operated with low speed fan, C and D with medium speed fan, E and F with high speed fan. The emissions results include CO 2 , CO, O 2 and particle mass concentrations are presented in this study. A performance analysis in terms of combustion efficiency together with different losses of the pellet stove is also discussed. The experimental results show that CO emissions obtained from the main combustion phase of the part load heat output experiments varied from 1215 mg/Nm 3 to 1450 mg/Nm 3 , while in the nominal load heat output varied from 50 mg/Nm 3 to 145 mg/Nm 3 . Also, the results show that CO emissions in the burnout phase from all the experiments were significantly higher than that in the startup phase followed by the combustion phase. The finding shows that higher CO emissions in the startup and burnout phase have influence on the total CO emissions. Particle mass emissions obtained from the combustion experiments operated with high fan speed varied from 10-15 mg/Nm 3 respectively and were much lower than the required limit value of standard EN14785 and other works. The combustion efficiency obtained from all the experiments for the low speed fan, medium speed fan and high speed fan was 92.8±1.2 %, 92.4±1.1 % and 92.7±1.2 % respectively and satisfied the required limit value of the standard. A rticle History : Received Sept 12 th 2017; Received in revised form March 17 th 2018; Accepted April 26 th 2018; Available online How to Cite This Article : Obaidullah, M., Bram, S. and De Ruyck, J. (2018) Investigation on Gaseous and Particle Mass Emissions from Automatically Fired Small Scale Heating System under Laboratory Conditions. Int. Journal of Renewable Energi Development , 7(2), 111-121. https://doi.org/10.14710/ijred.7.2.111-121 }, pages = {111--121} doi = {10.14710/ijred.7.2.111-121}, url = {https://ejournal.undip.ac.id/index.php/ijred/article/view/18359} }
Refworks Citation Data :
This study presents the experimental results on gaseous and particle mass emissions obtained from a bottom feed pellet stove of 2.5 kW output in part load heat and 5 kW output in nominal heat. The experiments were conducted in a stove manufacturing plant in the southern part of Belgium. Two combustion experiments (A and B) in part load heat output and four experiments (C, D, E and E) in nominal load were performed at three combustion phases: startup, combustion and burnout phase. The pellet stove was operated in different fan speeds varied from 900 rpm to 1250 rpm for the combustion experiments. Experiments A and B were operated with low speed fan, C and D with medium speed fan, E and F with high speed fan. The emissions results include CO2, CO, O2 and particle mass concentrations are presented in this study. A performance analysis in terms of combustion efficiency together with different losses of the pellet stove is also discussed. The experimental results show that CO emissions obtained from the main combustion phase of the part load heat output experiments varied from 1215 mg/Nm3 to 1450 mg/Nm3, while in the nominal load heat output varied from 50 mg/Nm3 to 145 mg/Nm3. Also, the results show that CO emissions in the burnout phase from all the experiments were significantly higher than that in the startup phase followed by the combustion phase. The finding shows that higher CO emissions in the startup and burnout phase have influence on the total CO emissions. Particle mass emissions obtained from the combustion experiments operated with high fan speed varied from 10-15 mg/Nm3 respectively and were much lower than the required limit value of standard EN14785 and other works. The combustion efficiency obtained from all the experiments for the low speed fan, medium speed fan and high speed fan was 92.8±1.2 %, 92.4±1.1 % and 92.7±1.2 % respectively and satisfied the required limit value of the standard.
Article History: Received Sept 12th 2017; Received in revised form March 17th 2018; Accepted April 26th 2018; Available online
How to Cite This Article: Obaidullah, M., Bram, S. and De Ruyck, J. (2018) Investigation on Gaseous and Particle Mass Emissions from Automatically Fired Small Scale Heating System under Laboratory Conditions. Int. Journal of Renewable Energi Development, 7(2), 111-121.
https://doi.org/10.14710/ijred.7.2.111-121
Article Metrics:
Last update:
Particle mass and gaseous emissions from small scale modern wood stoves
Renewable Energy - Technologies and Applications
Renewable Energy [Working Title]
Last update: 2024-11-18 17:34:40
This journal provides immediate open access to its content on the principle that making research freely available to the public supports a greater global exchange of knowledge. Articles are freely available to both subscribers and the wider public with permitted reuse.
All articles published Open Access will be immediately and permanently free for everyone to read and download. We are continuously working with our author communities to select the best choice of license options: Creative Commons Attribution-ShareAlike (CC BY-SA). Authors and readers can copy and redistribute the material in any medium or format, as well as remix, transform, and build upon the material for any purpose, even commercially, but they must give appropriate credit (cite to the article or content), provide a link to the license, and indicate if changes were made. If you remix, transform, or build upon the material, you must distribute your contributions under the same license as the original.
International Journal of Renewable Energy Development (ISSN:2252-4940) published by CBIORE is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.